![]() ![]() ![]() Therefore the face of the wheel is probably slightly angled which will straighten up when I tack the flat bar down. So I'm going to temporarily tack it down. I tried to clamp a piece of flat bar onto it to get it to 90 but the vibration moved it around. One thing i noticed after a while is that the rest is angled, not at 90 degrees. And I am sliding the dresser back and forth, not holding it still in one spot. The surface is much smoother which makes it easier to run the dial indicator on it but instead of being off. However, it's worse now than when I started. The small hose clamp keeps the diamond dresser running along the rest without going in and out with the wheel discrepancies. Well, I need a little more help - I'm evidentially doing something wrong. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
February 2023
Categories |